Verify the input voltage is a steady 12V DC.
Connect a magnetic door sensor to monitor door status. When the door is forced open, the system can trigger an alarm output.
Note: Verify label on your unit for exact terminal names and polarity. V2000-c Rfid Access Control User Manual
The relay timer dictates how long the lock remains open after a valid entry. Enter Programming Mode. Press 5 .
For further support, consult your distributor for hardware-level repairs. The V2000-c’s simplicity is its strength – there is no cloud to fail, no subscription fee, and no software to crash. Just security that works. Verify the input voltage is a steady 12V DC
| Error Symptom | Probable Cause | Solution | | :--- | :--- | :--- | | | Blown fuse on power supply or reverse polarity. | Check PSU, measure voltage at terminals 1 & 2 (must be 10-14V DC). | | Card beeps but lock doesn’t open | Lock wired to wrong relay (NO vs NC). | Swap lock wire from NO to COM or NC to COM. | | Lock opens for 1 second then closes | Insufficient power supply amperage (lock surge). | Upgrade to 12V DC 5A PSU. Add a capacitor across lock power. | | Continuous alarm after door closes | Door contact sensor (SEN) stuck or misaligned. | Check reed switch gap (<10mm). Set 16 0 # to disable temporarily. | | “Error” beep (two short beeps) | Command syntax error or user not found. | Re-enter command slowly. Use 14 to verify user exists. | | Master code not accepted | Someone changed it, or keypad is faulty. | Perform emergency reset (jumper method). | | RFID range is <1cm | Interference from metal or voltage drop. | Mount on non-metallic spacer. Check 12V at reader (terminal 2 & 10). |
The V2000-C RFID access control system consists of the following components: Note: Verify label on your unit for exact
1,000 to 2,000 users (depending on the specific firmware version) Card Reading Distance: 3–8 cm
Swipe the RFID card or fob close to the keypad reader. (The machine will beep once). Press # to confirm, then press * to exit. Adding Users (PIN Only) Enter programming mode. Press 1 . Enter a unique (e.g., 0005 ) followed by # . Enter a 4-digit to 6-digit PIN . Press # . Press * to exit.