Sharp Atomic Clock Spc373 User Manual [2021] Info

Press again to confirm. The minute digits will flash. Use UP/DOWN to adjust.

The Sharp Atomic Clock SPC373 Go to product viewer dialog for this item.

For the atomic synchronization to display the correct hour, you must select your local North American time zone and Daylight Saving Time (DST) preference. Time Zone Selection

The atomic signal is strongest at night. It may take up to 24 hours for the clock to successfully capture the signal and set itself to the exact second. Programming Guide: Manual Settings sharp atomic clock spc373 user manual

Press and hold the button for 3 seconds until the alarm hour digits begin flashing.

Sharp Electronics typically offers a from the date of purchase against manufacturing defects.

The 12/24-hour format will flash. Choose your preference, then press . Press again to confirm

Before adjusting the time, you must select your local time zone so the atomic signal updates correctly:

If the clock defaults to Eastern Time (or UTC):

The icon stopped flickering. The clock displayed —the signal was dead. The Sharp Atomic Clock SPC373 Go to product

Note: It can take anywhere from 5 minutes to 24 hours for the clock to successfully register the signal for the first time. Manual Settings and Adjustments

When you open the box, verify you have the following components:

Replace both AA batteries with brand-new alkaline batteries. Alarm icon is missing from display Ensure the AL_ON/OFF switch is set to the ON position. Inaccurate Temperature Direct sunlight or heat sources